*i am making this fabulous pattern with black, red, and yellow colors, representing german flag*. How to make adjustable bracelets with single knot. I noticed that in my last video, it was a bit confusing when i explained how to make the bracelets adjustable.
I Usually Make The Braided Ends About The Same Length As The Bracelet Itself.
Thread would work to if you wanted it to be less noticeable but it isn't as strong. Preparing the cord and beading. Place a piece of scotch tape about 2 in (5.1 cm) away from one end of your bracelet.
Now You Have A Knot On Your Braid (S).
Hold the loop in place with your index finger and. Separate the strings into 2 sections. There are 2 ways to make an adjustable knot;
Start By Making A Loop At The Cord End:
Pull at the bracelet by the loop to tighten the loop down onto the braid. Place some scotch tape over the end of the cord. Lay the extra string under the braids as shown.
To Do This You Will To Take The Left Free End Through The Loop That Your Hand Will Go Through Then Put It Over The Right Free.
It is super easy to create and is beginner friendly. Holding the knot cord about 1 to 2 inches from the end, make a loop. Then tighten the knot, sliding it toward.
